Today I was reconfiguring a Cisco 7513 with a RSP 16 and a FastEthernet module inside.
So I did a “erase nvram” and a “reload”. After booting I was surprised to see the following in my Terminal:
Would you like to enter the initial configuration dialog? [yes/no]:
Loading pxelinux.0 from 10.42.10.50 (via FastEthernet4/0/0): !!!
[OK - 13156 bytes]
So the box took an IP via DHCP and tried to netboot. (Un)fortunately it only breaks my terminal, so no worries! ;)
The Booting Linux on Cisco 7513 by Cyconet Blog, unless otherwise expressly stated, is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 Unported License. Terms and conditions beyond the scope of this license may be available at blog.waja.info.
0 Responses to “Booting Linux on Cisco 7513”
Leave a Reply